Smoked tail lights and guards

Discussion in 'Renegade Show & Tell' started by gnardog, Oct 4, 2018.

  1. gnardog

    gnardog New Member

    Joined:
    Oct 3, 2018
    Messages:
    9
    Location:
    Louisville, Colorado
    Smoked red tint + guards. Used a knife to cut out the Jeep grille Easter egg! Thoughts?
     

    Attached Files:

    chartied, RobotDwarf and Dgr401 like this.
  2. gnardog

    gnardog New Member

    Joined:
    Oct 3, 2018
    Messages:
    9
    Location:
    Louisville, Colorado
    iOS Image - 1993887567.jpg
     
    RobotDwarf likes this.
  3. Sprocket

    Sprocket New Member

    Joined:
    Mar 13, 2018
    Messages:
    11
    Location:
    Bainbridge, Pa
    Did you use film to cover the entire lamp of just over the reverse light X? Been wanting to smoke mine using film but the contours of the light are really intricate

    looks good!
     
  4. gnardog

    gnardog New Member

    Joined:
    Oct 3, 2018
    Messages:
    9
    Location:
    Louisville, Colorado
    I used a pre cut film specifically for Renegade taillights, but I wouldn't recommend that route. As you said, the countours are intricate... It ended up peeling off a few weeks ago. I would recommend a roll of film that you can custom cut and use a heat gun to ensure good adhesion! A hair dryer won't cut it.
     
    Sprocket likes this.
  5. Sprocket

    Sprocket New Member

    Joined:
    Mar 13, 2018
    Messages:
    11
    Location:
    Bainbridge, Pa

    Thanks Gnar
     

Share This Page