Plastidip emblems

Used some Plastidip to try and match all the red emblems to the grey of the 4x4 emblem. Came pretty close. I'll probably just have to do the 4x4 emblem to match exactly.

 

What dip did you use? The metallics anthracite should have been spot on.

 

I used the "Gunmetal". It's really close. I had the dark grey also, but it seemed a tad too dark so I sprayed over it with gunmetal.

 

Side by side... It's tough to get an accurate color, but u can see the difference in shades.

 

Gotcha...I have thought about doing the same...I used the metallics anthracite for my truck emblems and wheels, and it looks like that would be pretty dang close to what's on the Jeep

 

Looks like anthracite may be a lil dark as well...idk

 

I think I'm gonna spray over it with the darker colour. It's a little too light. If it ends up too dark I'm gonna do the 4x4 with the darker colour.
When I feel a tad more adventurous I may redo the "renegade" on the doors with the darker grey and do a black outline to match the "Jeep" emblem.... But that will require a lot of patient masking that I'm not sure I have haha

 

Went ahead and sprayed over them again with the dark grey. It's not perfect, but it's way closer. And I'm way happier with it.

 

Back end

 

Oh yea! Looks good!

 

did you remove to paint it or left it on?

 

I left them on. Just masked a square around them leaving a couple inches so I could peel back the Plastidip. Took less than two hours start to finish.

 

I used the black on my Black n Blue!!

 

you did your rims fatkid66?

 

Yes i did. wasnt feelin the black and silver look!!