Failed harness on the rear drive side light assembly

Discussion in 'Renegade Stock Tech' started by helldorado, Oct 10, 2016.

  1. helldorado

    helldorado New Member

    Joined:
    May 15, 2016
    Messages:
    27
    Media:
    9
    Albums:
    2
    Location:
    NOLA
    Anybody else experience that or something like it? Was driving and all of a sudden I got warnings that my tail light, turn signal and backup lamp had all failed and it was the driver side that was out. Swapped the bulbs side to side, no help, all the bulbs were good. I plugged the assemblies into the opposite side harnesses and everything worked beautifully. Well, except that you can't reinstall the actual housings that way, lol. Dealer determined it was a bad connector and the only way to fix it was the replace the entire harness.

    My Renegade has been sitting at the dealer for about 8 days now, still waiting on the replacement harness to come in. What do you think the odds are I'll hit a full 2 weeks? o_O
     
  2. JeepCares

    JeepCares Active Member

    Joined:
    Jul 24, 2015
    Messages:
    131
    Location:
    Mopar Headquarters, MI
    Sorry about the wait, helldorado! Did the dealership tell you there was an issue with the part order? I'd be happy to call and check the status, unless you're set on getting to that 2 week mark :) Just PM your VIN and the dealership name if I can help!

    Kori
    Jeep Social Care Specialist
     
  3. helldorado

    helldorado New Member

    Joined:
    May 15, 2016
    Messages:
    27
    Media:
    9
    Albums:
    2
    Location:
    NOLA
    Thanks Kori! PM Sent.
     
  4. JustinBalboa

    JustinBalboa Active Member

    Joined:
    May 25, 2015
    Messages:
    420
    Location:
    Lakewood, CO
    The renegade tells you when you have a light out?
     
  5. helldorado

    helldorado New Member

    Joined:
    May 15, 2016
    Messages:
    27
    Media:
    9
    Albums:
    2
    Location:
    NOLA
    Yep. It's also why you can't swap out the stock bulbs for LED unless they're CANBUS compatible in most cases.
     

Share This Page