Rugged ridge spacers

Discussion in 'Renegade Modified Tech' started by kharris, Dec 14, 2018.

  1. kharris

    kharris New Member

    Joined:
    Jun 26, 2017
    Messages:
    14
    Location:
    Nc
    so I got the rugged ridge 1.25 inch wheel spacers, and with steel rims the heads of the factory lugs are too high so the wheel does not fit flush with the spacer. Also it appears that there is only about half of the threads making it into the hub after the lug goes through the spacer. Is that enough?
     
  2. Nathaniel

    Nathaniel Active Member

    Joined:
    Mar 19, 2018
    Messages:
    144
    Location:
    DeLand Florida
    oh no no no, you need to get lug bolts that are made for spacers so the tire can mount flush and you need ALL the threads.
    I would greatly suggest taking those spacers off immediately, I've seen tires fly off of cars going down the highway because they didn't have spacers properly installed, the result of such a thing happening isn't pretty to say the least.
    And yes, this will cost a bit more but get with a local shop for the install, they should have the right bolts and get everything set up right for you.
     
  3. kharris

    kharris New Member

    Joined:
    Jun 26, 2017
    Messages:
    14
    Location:
    Nc
    Oh don’t worry I stopped the install as soon as I saw they were not flush.
     

Share This Page