DayStar creaks

Discussion in 'Renegade Modified Tech' started by FireHawk, May 30, 2016.

  1. FireHawk

    FireHawk Active Member

    Joined:
    Feb 29, 2016
    Messages:
    330
    Location:
    NC, United States
    Anybody else having a little bit of creaking/squeaking that wasn't there before? Not a big deal, I only hear it at crawling speeds or backing out of the driveway, just curious.
     
  2. Sharpshooter9000

    Sharpshooter9000 Member

    Joined:
    Aug 31, 2015
    Messages:
    71
    Location:
    Lomita
    Do you also here it while turning? I had that issue too but I had no lift. It turns out both my lower control arms were bad
     
  3. FireHawk

    FireHawk Active Member

    Joined:
    Feb 29, 2016
    Messages:
    330
    Location:
    NC, United States
    Nope, no sound when turning. Just low speed, mostly backing out of the garage or in parking lots.
     
  4. Sharpshooter9000

    Sharpshooter9000 Member

    Joined:
    Aug 31, 2015
    Messages:
    71
    Location:
    Lomita
    Try to let the car roll and brake hard, let me know if you still here creaking
     
  5. FireHawk

    FireHawk Active Member

    Joined:
    Feb 29, 2016
    Messages:
    330
    Location:
    NC, United States
    Ok I'll try it on the way to work.
     
  6. Thawk

    Thawk Active Member

    Joined:
    Feb 3, 2016
    Messages:
    278
    Location:
    Tempe Arizona
    Check your tie rod and sway bar connections. I disconnected the sway bar and didn't get it tight enough and someone els3 mentioned the lower sway bar connection
     
    Wookie Renegade likes this.
  7. dee35124

    dee35124 Active Member

    Joined:
    Mar 16, 2016
    Messages:
    195
    Media:
    2
    Albums:
    1
    Location:
    Alabama
    Same creaking here
     
  8. FireHawk

    FireHawk Active Member

    Joined:
    Feb 29, 2016
    Messages:
    330
    Location:
    NC, United States
    The biggest noise in mine is coming from the driver side rear area, so I don't think its the sway bar. I checked under the Jeep, and it looks like they didn't really trim any of the skidplate where the new DayStar bracket contacts it. They just hit it with a grinder from the looks of it, and the bracket may be contacting it and causing some of the noise. Ill be setting up an apt to have all the bolts went through and retorqued after 500-700 miles and ill have them take a look at it then.
     
  9. FireHawk

    FireHawk Active Member

    Joined:
    Feb 29, 2016
    Messages:
    330
    Location:
    NC, United States
    You did the G Force lift, are their spacers "plastic" or whatever the DayStars are made of? I wonder if its just the material of the spacer blocks, if so there probably isn't much that can be done about it.

    As long as it isn't damaging anything, I can get around the noise. That's what rock music is for:D
     
    pitsteelrsfan and Jack D like this.
  10. dee35124

    dee35124 Active Member

    Joined:
    Mar 16, 2016
    Messages:
    195
    Media:
    2
    Albums:
    1
    Location:
    Alabama
    I have an update. I took the Jeep to the dealership yesterday. They said that the spring was JUST a bit off from where it should be. They fixed it and the creak is gone. To answer your question though, the G Force lift is all metal, no plastic....
     
  11. dee35124

    dee35124 Active Member

    Joined:
    Mar 16, 2016
    Messages:
    195
    Media:
    2
    Albums:
    1
    Location:
    Alabama
    It was just from installation error....
     
  12. MLH24

    MLH24 Member

    Joined:
    Sep 14, 2015
    Messages:
    45
    Location:
    Santa Monica, CA
    Mine creaked too after the initial install. Took it in for tightening and it's been months now with nothing.
     
  13. FireHawk

    FireHawk Active Member

    Joined:
    Feb 29, 2016
    Messages:
    330
    Location:
    NC, United States
    That's what im hoping to hear from mine. I will be out of town next week but hope to get it to the shop when I get back in to have them go through all the bolts again. Ill be around 7-800 miles since the install by then.
     
  14. FireHawk

    FireHawk Active Member

    Joined:
    Feb 29, 2016
    Messages:
    330
    Location:
    NC, United States
    Could be a possibility, was your noise in the front or rear?
     
    Clifford's Red Rocket likes this.
  15. dee35124

    dee35124 Active Member

    Joined:
    Mar 16, 2016
    Messages:
    195
    Media:
    2
    Albums:
    1
    Location:
    Alabama
    It was the right front
     
  16. Chad Lohrenz

    Chad Lohrenz Active Member

    Joined:
    Jan 27, 2016
    Messages:
    149
    Location:
    Lincoln, Il
    Mine sounds like shit! Dealer replaced front driver strut and now replacing sway bars. Sounds like it's falling apart. I've had my lift about 8-10 months.


    Sent from my iPhone using ToasterJeep mobile app
     
  17. FireHawk

    FireHawk Active Member

    Joined:
    Feb 29, 2016
    Messages:
    330
    Location:
    NC, United States
    Forgot to update this thread: my rear creaking/squeaking has gone away on its own. Guess it just needed to be seated it good to settle down. Lucky me!
     
  18. MLH24

    MLH24 Member

    Joined:
    Sep 14, 2015
    Messages:
    45
    Location:
    Santa Monica, CA
    Same for me - just this past week.
     
  19. Chad Lohrenz

    Chad Lohrenz Active Member

    Joined:
    Jan 27, 2016
    Messages:
    149
    Location:
    Lincoln, Il
    Just to clarify... they did not replace sway bar links. My dealer installed my lift and they forgot that the front sway bars links are Daystar. They are saying that my Daystar sway bar links are wore out. Anyone else have this issue? I find it hard to believe that the sway bar links are "wore out'.


    Sent from my iPhone using ToasterJeep mobile app
     
  20. FireHawk

    FireHawk Active Member

    Joined:
    Feb 29, 2016
    Messages:
    330
    Location:
    NC, United States
    I don't seem to have any of these problems out of my lift. I can notice a small bit more sway in the rear when going over railroad tracks, but other than that people would never know it wasn't stock. I had some initial creaking in the left rear suspension, but it cured itself and now all is good.
     

Share This Page